DeWalt D28754 Guide D'utilisation page 9

Fig. D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
Installing Abrasive Wheels (Fig. D, E)

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
1. Lay unit on a firm surface with bottom of shoe
facing up.
2. Loosen depth adjustment wing nuts
allow easiest access to spindle nut, then tighten wing
nuts to hold shoe in place.
3. Using supplied 1–1/8" (28 mm) open end wrench,
remove spindle nut , outer clamp washer
9
used wheel if one is installed. Hold spindle from
11
turning with spindle lock button. Spindle threads are
right hand.
11
12
13
8
Fig. E
3
4. Make sure inner clamp washer
5. Engage spindle lock button and tighten nut with
6. Turn wheel by hand to ensure it is properly centered.
5
7. Be sure to readjust shoe for proper depth of cut.

3 , move shoe to
and
10
Depth of Cut (Fig. A, F, G)

9
10
5
are engaged with spindle flats. Slip wheel through
bottom of shoe and slip wheel over spindle. Be sure
wheel goes over pilot diameter of inner clamp washer.
Slip on outer clamp washer. Start threading on spindle
nut which will self align outer clamp washer.
wrench. Do not over tighten spindle nut.
The wheel should not hit the shoe, guard or nut. The nut
and flanges should be tight.
CAUTION: Only use 12" (305 mm) Type 1/41 wheels
with 1" (25.4 mm) arbor hole with this tool. Never
force a wheel onto the machine or alter the size of the
arbor hole.
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
English
is in place and ears
12
7