Astralpool MAX 5 PRO Guide De Démarrage Rapide page 12

Operating the pool cleaner - Quick start guide
1. Place the power supply (transformer) at least 3.6 meters / 11.8 feet from the pool and at
least 12 cm / 4 Inch above the surface (fig.1). The transformer will supply low voltage to
the cleaner.
2. Uncoil the cable.(fig.1a)
unit
3. Place the unit in the water.
Turn the unit side to side
in the water to allow air to
escape from the body
and then let the cleaner
sink to the bottom of the
pool (fig.3). Then, spread
the cable over the
surface of the pool as
evenly as possible (fig.1).
4. Plug the cable into the power supply. Depending on your model (Type I or Type II),
5. Plug the power supply into a grounded outlet. Ensure that the electric outlet has been
6. The light will glow indicating that the system is " ON " and the pool cleaner will start the
3.6 m/ 11 .8f t
12 cm
(4.7 inch)
1
1a
3
11
make sure the key on the plug corresponds exactly with the key slot on the socket of
the power supply (fig.3a). (See details on the next page)
properly grounded (fig.3b).
cleaning cycle. The unit keeps record of the number of cleaning cycles. Only an
authorized service center can display the accumulated cleaning cycles.
Type I
Type II
IMPORTANT:
Please be sure to always keep your pool cleaner properly stored anywhere
between 10 to 40 degrees Celsius (50 to 104 degrees Fahrenheit). This will
keep the motors, plastics and seals protected. Failure to comply will result in
loss of warranty.
Robot can be used in water with temperatures ranging from 13°C to 35°C (55°F
to 95°F). However, the recommended optimal temperature is between 22°C
and 32°C (72°F and 90°F)
3a
3b
4