Alarm Messages; Manual Activation Of The Emergency Status - ECOFOREST ecoGEO Basic Manuel D'utilisateur

If the problem cannot be solved using these instructions or abnormal heat pump operation is detected, please contact the technical
service and request that the installation be checked.

4.2. Alarm messages

The heat pump performs constant monitoring of multiple operation parameters. If any of these parameters is not within the
normal range of values, the controller will activate an alarm and display a message showing the error, which will be recorded in the
ALARMS menu.
The heat pump will not allow compressor start-up if there is an alarm activated. The
indicate the error and the EMERGENCY status will be activated automatically.
Different situations can occur, depending on the problem.
Active alarms
The active alarms show errors that are occurring at that precise moment. The home page of the ALARMS menu shows consecutive
screens with text describing the cause of the alarm. The
If the problem is solved, these alarms disappear and the heat pump starts to operate automatically. The
indicate that the error has been solved. The
Block due to repeated alarms
Certain alarms are critical for heat pump operation. If they are repeated more than 5 times on the same day, they block the heat
pump permanently. The button lights up in red and remains on and the main screen shows
Even after the problem is solved, the heat pump has to be unblocked manually from the ALARMS menu to start it up again.
Alarm log
The alarms menu contains a log where the last 50 errors can be viewed.

Repeated alarms indicate that there is a malfunction in the installation. Contact the technical service
as soon as possible to check the installation.
DANGER!

4.3. Manual activation of the EMERGENCY status

If the heat pump does not start up and there are no active alarms, the EMERGENCY status can be activated manually from the
On/Off menu (Refer to Section 3.9). This will enable the heat pump to use the auxiliary units to provide the emergency services
while a solution to the problem is found.
button lights up in red and remains on and the main screen shows
button will switch off when the alarm registry is accessed.
50
User manual ecoGEO
button will light up in red and remain on to
button flashes red to
.
.