Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Assembly
To connect the hose to the vacuum cleaner, insert the
connecting piece at the end of the vacuum hose into
the air intake opening of the vacuum cleaner. The hose
will click into place. To remove it, press on both buttons
A
A
[A] and gently pull out the hose connector from the air
intake opening.
Insert the handle of the vacuum hose into the telescopic
tube. Rotate the tube in the handle until a "click" is
B
heard. The handle is properly connected. To remove
the handle, press button [B] and pull the handle out of
telescopic tube.
Insert the telescopic tube into the floor nozzle and
rotate it until a slight "click" is heard. The floor nozzle is
C
properly connected. To remove the floor nozzle, press
button [C] to remove the nozzle from the telescopic
tube.
To set the length of the telescopic tube, use your thumb
to press the slider [D] in the direction of the arrow. Pull
or push the telescopic tube to the required length.
The suction power can be regulated with the slider
(suction control) on the handle [E]. You can use this
slider to reduce the suction power to adapt the
movement/gliding of the floor nozzle on low pile carpet.
D
For vacuuming hard floors, you should keep the slider
closed.
E
The appliance is now ready to use.
7
Publicité
Table des Matières
