Soniclean WhisperJet C2 Mode D'emploi page 11

Maintenance
Cleaning
Replacing the
filter bag
[F]
[G]
[H]
CORRECT
[I]
Turn off the vacuum cleaner and unplug it before
performing any cleaning or maintenance steps.
Do not use any cleaning agents, abrasives or
alcohol. These may damage the external housing.
Do not use the vacuum without a filter bag, motor
protection filter and the ULPA exhaust filter.
1. Open the dust compartment lid by pulling the
unlocking handle [F].
2. Tilt the lid of the appliance back completely.
3. Slide the lever on the filter bag mounting system
to the unlocked position [G]. You can now
remove the filter bag.
4. To install a new filter bag, insert the filter bag
collar into the mounting system, making sure that
the filter bag is aligned and centered with the
mounting system [H]. There is no need to twist
the bag; just make sure its seated, centered and
aligned.
INCORRECT
5. Slide the lever on the filter bag mounting system
to the locked position [I] to seal the filter bag to
the vacuum. You are now ready to start/resume
vacuuming.
Warning!
Warning!
Warning!
10