Soniclean WhisperJet C2 Mode D'emploi page 12

Maintenance
Replacing the Motor
Protection Filter
H
Replacing the ULPA
Exhaust Filter
I
11
Attention!
Ensure that the motor protection filter always
covers the vacuum motor completely and that no
dust can reach the motor.
1. Open the dust compartment and remove the dust
bag (see "Replacing the filter bag").
2. Press the tab [H] and tilt it forward to remove the
motor protection filter.
3. Remove the motor protection filter and install a
new motor protection filter.
4. Close the motor protection filter grill.
5. Install the dust bag again and close the dust
compartment lid (see "Replacing the filter bag").
Note!
Replace every 6-12 months (depending on use).
The ULPA filter is located under the air outlet grill.
1. Remove the air outlet grill by pressing the tabs [I].
2. Remove the ULPA filter and replace it with a new
ULPA filter.
3. Re-install air outlet grill and press it until a click is
heard.