SPL-Technik 310 Manuel D'utilisation page 7

Possible failures and methods for correcting them
Problem Possible cause
Power switch is in the OFF position.
Transmitter
indicator
is not
Batteries have been inserted without
illuminated
attention paid to the polarity.
Batteries are insufficiently charged.
Infrared light beam from the
Model does
transmitter is not reaching the
not react
model's receiver.
to the
transmitter
signal
Powerful light sources, sources of
infrared radiation and sunlight impair
the quality of the IR signal
Rotation speed of the rotors is
Model does
not sufficient.
not gain
altitude
Model is not sufficiently charged.
The manufacturer reserves the right to change the instructions, the kit elements and the operating
specifications without advance warning. Depending on a specific shipment, items may differ
slightly from what is described in the instructions.
Solution
Put the power switch in the
ON position.
Pay attention to polarity when
you reinsert the batteries.
Replace or charge the batteries.
Reduce the distance between
the model and the transmitter,
be certain that there is no
interference disturbing the signal.
Check to see there is no
interference or choose other
premises for the flights.
Increase the rotor rotation by
smoothly moving the gas stick.
Fully charge the model's battery
in accordance with the
instructions.
7