SPL-Technik 310 Manuel D'utilisation page 4

Safety rules
15. Always look at the model; don't concentrate attention on the transmitter.
16. Don't stand behind objects which could prevent you from quickly going up to the
model.
17. Watch closely the direction and height of the flight; always compensate for any
deviation from the intended direction of flight by small and steady movement of the
transmitter sticks. The main error of beginning pilots is jerky movement of the sticks in
extreme positions – this always leads to loss of control and to the model's falling down.
18. Trim the model before each flight.
19. Never grab the model by rotor parts.
20. Always switch off the model's power, even if the rotors have stopped automatically.
21. Never close and do not tape down the transmitter emitter.
22. Never tape onto the model additional parts or stickers.
23. Don't let children start up the model without adult supervision.
24. Never start up the model if it has damaged parts.
25. Do not disassemble and do not make alterations in the model's construction.
Parts of the helicopter's power supply
1. Helicopter battery {installed on board) – 3.7V 85mAh
2. Power supply parts of the transmitter: 6 АА 1.5V batteries (not included).
Installation of the transmitter batteries
1. Open the lid of the battery compartment,
put in place the б AA batteries (not included in
kit), being sure that the polarity is correctly
aligned.
2. Close the lid of the battery compartment.
Charging the helicopter
Turn the power supply switch of the helicopter to
the OFF position.
Pull out the charging cable from the compartment
on the front side of the transmitter and connect it to
the charging socket of the helicopter. Meanwhile, the
helicopter and transmitter must be switched off.
Switch on the transmitter. Meanwhile the charge indicator will shine green.
The charging time is around 30 minutes. When the battery is fully charged, the indicator
switches off. Your helicopter is now ready for flight.
4