Hands-Free Unit Control; Hands-Free Control Screen - Kenwood KCA-BT100 Mode D'emploi

Hands-Free Unit Control

Hands-Free Unit control

Hands-Free Control screen

TEL
Hands-Free Control screen
Hands F r e e
K E N WO O D
1
P 1
1
2
P 2
4
3
P 3
6
7
4
+ *
5
S e t Up
Control screen
DV D V I D E O
REP
N e x t N e x t
T i t l e 1 C h a p
K E N W O O D
1 Displays the Search for Phone Book screen.
(See the <Calling by Phone Book>, page 15)
2 Displays the Out Going Calls screen.
(See the <Redialing>, page 16)
3 Displays the Incoming Calls screen.
(See the <Redialing>, page 16)
4 Switches between the private and hands-free
modes (only when a call in progress).
5 Displays the Hands-Free Set Up screen.
(See the <Setting up the Hands-Free Phone>, page
16)
6 Enter three phone numbers for quick dialing.
(See the <Quick Dialing>, page 14)
7 Enters a phone number.
(See the <When Dialing>, page 14)
12
|
English
(For Monitor receiver)
Or when a call
comes in ...
8 9 10
AUTO
11
0 1 2 3 4 5 6 7 8 9
15
2 3
12
5 6
Clear
8 9
13
#
0 14
7
Return
13:50
16
TEL
IN
TIME
SCRL
3 T 0 : 0 5 : 2 0
8 Displays the signal strength.*
The more the number of bar segments, the
stronger the signal.
9 Displays the present Auto Answering status
When Auto Answering is on:
When Auto Answering is off:
p Displays the battery drain of the cell-phone.*
The more the number of bar segments, the higher
the battery level.
q Starts the call.
w Ends the call.
Clears the phone number being entered.
e Clears the entered phone number.
r Returns to the previous screen.
t Displays the calling and called phone numbers.
If you have registered a phone number in the
Phone Book, the destination person name is
displayed.
y Displays the status of connection with the cell-
phone.
White: The cell-phone is connected.
Orange: The cell-phone is not connected, or it is
outside the service range.
• While your car is moving, some functions are
disabled for safety's sake. The buttons associated
with the disabled functions become ineffective if
pressed.
• When the Hands-Free Control screen appears, the
name of the connected cell-phone is displayed for 5
seconds.
• * Since the number of steps of the control unit is
different from that of the cell-phone, the statuses
displayed on the control unit may discord from
those displayed on the cell-phone. No status
is displayed if information about it cannot be
obtained.
• Setting the cell-phone in the private mode can
disable the hands-free function.
AUTO