Integration Into An Existing Door Bell System; Changing The Flashlight Covers; Marking Panel; Important Instructions - REV Ritter 0514902555 Mode D'emploi

Gong sans fil
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The person being paged can also be moving freely within a range of
up to 50m when it is activated (see text. no. 10). The paging function
can be stopped prematurely by pressing the reset function
rally, you can also use all signal types (chimes, flashlight or chimes
and flashlight) when the paging function is activated.

7. Integration into an existing door bell system

The radio-controlled chimes are suitable for integration into an exi-
sting door bell system. Two operating formats are available for this:
You have an existing door bell system with transformer and would
like to operate the radio-controlled chimes in another room parallel
to the existing chimes (illus.
II
☛ C onnect the contacts A and C of the transmitter  parallel to the
existing door bell system . If you have no function or an auto-
repeat, switch terminals A and C over.
You have an existing door bell button and would like to operate this
together with the radio-controlled set (illus.
☛ C onnect the contacts B and C of the transmitter  parallel to the
existing door bell button .

8. Changing the flashlight covers

To change the coloured flashlight cover
receiver and press the selected replacement cover in place in the
four retaining holes.
18
)
)
III
, pull it carefully off the

9. Marking panel

Open the marking panel
. Natu-
a written tab, e.g. with your name, behind the clear cover. Close the
marking panel by applying even light pressure to the clear cover.

10. Important instructions

• T he range between the transmitter and receive is max. 50m in an
open area. The radio signal's strength depends on constructional
conditions when being transmitted through walls, panelling, furni-
ture and other obstacles – walls, in particular reinforced concrete
walls and ceilings – lead to a reduction in range.
• R eception can be severely impeded by screening from metal parts
so that a transmission of the signal is no longer possible. For this
reason, never attach the transmitter  to a metal surface.
• T o install, drill appropriate holes at chosen installation point and
fasten the individual devices into place using the provided fasten-
ing materials. Test the function of the device at the chosen installa-
tion point first before completing final installation.
• A lthough the transmitter  is spray-water protected and therefore
suitable for use outdoors, it should not be subjected to direct sun-
light for greater lengths of time as this can have a negative effect
on the colour and materials.
at the provided indentation and insert
19

Publicité

Table des Matières
loading

Table des Matières