Télécharger Imprimer la page

impekk Evok 150-01 Instructions D'installation page 13

Publicité

9
INSTALLATION DES SUPPORTS DE PORTE / INSTALLING THE DOOR BRACKETS
Installer les supports de porte en les alignant avec les barres de support du cadre.
Les supports de porte doivent pointer vers le bas.
The door brackets must point downward. Install the door brackets in alignment with
the support bars on the bed frame.
*Installez la poignée (non- incluse) à l'autre bord de la porte durant cette étape.
Poignée doit être installée à une hauteur dont l'utilisateur pourrait tirer le lit vers le
bas (approximativement à 1/3 du haut de la porte).
Install the handle (not included) on the other side of the door during this step. Handle
should be mounted at a height to comfortably allow the user to pull the bed down
(approximately 1/3 of the way down from the top of the door).
10
INSTALLATION DES PORTES / INSTALLING THE DOORS
10.1
Accrocher les supports de porte au cadre. Pousser vers le bas jusqu'à ce
qu'elle soit bien fixée. Centrer les portes.
Hook the door brackets onto the frame and push down until they are firmly
in place. Center the doors on the frame.
Les dimensions (à droite) sont pour la
position de ce trou.
Measurements (right) are for the
placement of this hole along the doors
Q
x 24
G
x12
.
102mm
4"
102mm
4"
Haut
Top
Bas
Bottom
256mm
10
"
1/16
714mm
28
"
1/8
714mm
28
"
1/8
11

Publicité

loading

Produits Connexes pour impekk Evok 150-01