Levita BD-4603 ALB Manuel D'utilisateur page 23

The monitor features a 2 zone memory capability. Each memory zone holds at least 60 measurements
• When the monitor is off, please press "M" button to show the average value of the latest three
records for the selected user.
• Press "M" or "S" button to get the record you want.
• The memory position, corresponding date and the corresponding time will be shown.
Note: If you want to check another user's records, please turn off the BPM when it is in the memory
mode, then follow the steps of Select the User to select the user. Press "START/STOP" button to
confirm your selection.Then press "M" button to check the measurement records.
Caution: The most recent record (1) is shown first. Each new measurement is assigned to the first (1)
record. All other records are pushed back one digit (e.g., 2 becomes 3, and so on), and the last record
(60) is dropped from the list.
14 Delete records
If you did not get the correct measurement, you can delete all results of the selected user by following
steps below.
• Hold pressing "M" button and "S" button at the same time when the monitor is in the memory
recall mode, the flash display "dEL ALL" will show.
• Press "S" button to confirm deleting, the LCD will display "dEL dOnE", and then the monitor will
turn off.
• Note: To exit out of delete mode without deleting any records, press "START/STOP" button
before pressing "S" button to confirm any delete commands.
• If there is no record the display will show three dashes
23
BD-4603 ALB/ALS