BD-4603 ALB/ALS
11
Applying the cuff
12
Taking measurement
•
When the batteries are installed.
•
Press the start/stop button to start measurement. After all segments are displayed, the cuff will
inflate to a level that is right for you.
•
If the cuff doesn't stop inflating, remove the cuff immediately. To stop the measurement, press
start/stop button. The cuff will deflate right after.
•
After the initial inflation of the cuff, the pressure will slowly decrease and when a pulse is
detected, the heart rate symbol will start flashing.
•
When the measurement is finished, the systolic pressure, diastolic pressure, heart rate and
WHO indicator will be displayed and saved.
•
Press the start/stop button to power off otherwise the monitor will automatically turn off after 1
minute if no button is pressed.
13
Recall the records
After each measurement, the systolic and diastolic pressure, heart rate with the time and date will be
automatically stored.
22
1.
Remove all watches, jewellery, etc. prior to
attaching the Arm cuff.
2.
Press your brachial artery by two fingers
approximately 2,5 cm above the elbow on the
inside of your left arm to determine where your
strongest pulse is.
3.
Slide the end of arm cuff furthest from the tube
through the metal ring to a loop. The smooth
cloth should be on the inside of the cuff. The
Velcro will be on the outside of the cuff.
4.
Put the left arm through the cuff loop. The
bottom of the cuff should be approx. 1,5 cm
above the elbow. The cuff should lie over the
brachial artery on the inside of the arm.
5.
Pull the cuff so that the top and bottom edges
are tightened around your arm.
6.
When the cuff is positioned properly, press the
Velcro firmly against the pile side of the cuff.
The metal ring will not touch your skin.
7.
Relax your entire body, especially the area
between your elbow and fingers. Place your
elbow on a table so that the cuff is at the same
level as your heart. Avoid leaning back while
the measurement is being taken.