System Info - Cameo H2 D Manuel D'utilisation

Wireless = W-DMX settings
Power = Mode
Software Update = Only for servicing purposes
Factory Reset = Reset to factory settings
SYSTEM INFORMATION (System Info)
Starting from the main display, press MENU to go to the main menu. Using UP and DOWN, now select the System Info menu option and
press ENTER to confirm your selection.
This will take you to the submenu which will let you access system information (see table, use UP and DOWN to select, press ENTER to
confirm, use UP and DOWN to change status, press ENTER to confirm).

System Info

Firmware = Displays the device
firmware
Temperature = Displays temperature of
LED unit
Operation Hours = Displays operating time
10
W-DMX On/Off On = W-DMX activated
Off = W-DMX deactivated
Reset Press ENTER = disconnects paired transmitter and puts it in
"ready to pair" mode
Constant Constant brightness over long periods of time
Maximum Maximum brightness
Reset? Reset to factory settings: Press ENTER to reset, MENU to
cancel
Firmware
V1.xx
LED xxx°C / xxx°F
C/F Unit Celsius (= displays in degrees Celsius)
Unit Fahrenheit (= displays in degrees Fahrenheit)
Operation Hours Displays the total operating time in hours and minutes
xxxx:xxh