Troubleshooting Guide - Altrad Belle MPC 300 Manuel De L'opérateur

GB
Problem
Engine will not start.
Engine still will not start.
Unit will not vibrate.
Asphalt adhering to plate.
Paving blocks damaged.
Low travel speed (plate sinking).
GB
The Altrad Belle warranty is against defects in design, materials and workmanship.
The following are not covered under the Altrad Belle warranty:
operation or user maintenance instructions.
3. Transportation or shipment costs to and from Altrad Belle or their recognised agents, for repair or assessment against a warranty
claim, on any machine.
4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty.
· Drivebelt/s
· Engine spark plug
Altrad Belle and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other
damages, losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
For warranty claims:
Write to:
Altrad Belle Warranty Department,
Sheen, Nr. Buxton
Derbyshire
England.

Troubleshooting Guide

Cause
No fuel.
Engine switched off.
Spark plug fouled.
Engine cold.
Major Fault
Drive belt tension loose.
Eccentric Shaft damaged.
Plate in direct contact with material.
Over compaction.
Moisture content too high or too low.
Warranty
12
Remedy
Open fuel tap.
Fill fuel tank.
Switch engine on.
Clean and reset plug gap.
Close choke.
Honda, open choke, fully open throttle, pull
Contact Agent or Altrad Belle.
Adjust belt tension.
Replace Eccentric Shaft
Use a water spray system.
Use a paving pad.
Remove and relay.
Remove some of the material.
Remove material and adjust.