Altrad Belle MPC 300 Manuel De L'opérateur page 10

GB
WARNING
1
2
3
4
5 6
CAUTION
Stopping the engine
Starting the engine
the OPEN position.
3. Turn the engine ON / OFF switch clockwise to the 'I' position.
gine resistance is felt, then let starter return.
warms up.
MPC300' to where it is required.
NEVER leave the engine running whilst moving or transporting the 'MPC300', even if it is only a short distance.
NOTE:- Once the machine has been started, the 'MPC300' should start vibrating and therefore the machine will also move in a
forward direction. Always check the machine for any unusual noises. If any of these occur, stop the machine immediately and refer
to the troubleshooting section.
The vibrator will not only cause the baseplate to vibrate but will also cause the machine to travel forward. During normal operation
you should not have to push the 'MPC300' but allow it to travel at its own pace.
The speed of travel will be determined by the condition of the surface being compacted.
If the surface to be compacted is on a slope, great care must be taken when controlling the 'MPC300' direction of travel. Work up
and down a slope not across.
'MPC300' over the surface in an organised pattern until the required compaction has been achieved.
Where there are a number of different layers to be compacted on top of each other, compact each layer individually.
Operating Instructions
Before you operate or carry out any maintenance on this machine YOU MUST READ and STUDY
this manual.
Honda GXH50
4. Engine Oil Filler / Dipstick,
5. Engine Oil Drain Plug
7. Engine ON/OFF Switch
7
The optimum engine RPM has been pre-set at the factory; DO NOT ADJUST THE ENGINE RPM.
Failure to comply may result in damage to the machine or the warranty becoming void.
'MPC300'.
10
-