Starting-Up; Device Operation; Overheat Protection - SilverCrest SEK 2000 B2 Instructions D'utilisation Et Consignes De Sécurité

5. Starting-up

Please find a suitable location for the device before
starting it up.
For safe and trouble-free running of the device,
choose an installation location which meets the
following requirements:
– The floor should be firm, flat and horizontal.
– The device should be set up at least one metre
away from furniture, curtains and other easily
flammable objects.
– Do not place the device in a hot, wet or very hu-
mid environment.
– A grounded socket protected by a residual-current
device with overload protection should be availa-
ble in the vicinity of the device.
– The power socket should be easily accessible so
that the mains connection cable can be easily di-
sconnected, if necessary.
– Extension cords are prohibited.
Plug the device cable into the grounded power
socket.
IMPORTANT! The cable must remain on the rear-
side of the device and must not come into contact
with any hot elements.

5.1 Device operation

The device is operated via the operation panel
2 and the thermostat 3 on the right-hand side
(Fig. 5).
The first switch with the [
the flame effect on and off. The flame effect can
be used with or without the heating function. If
the switch is set to the [ O ] symbol, the flame
effect is switched off. If you press the switch to
the left [‒], you will activate the device.
For a low amount of heating, switch the first hea-
ting level with the [ I ] symbol to the [‒] symbol
to turn it on and to the [ O ] symbol to turn it
off. The heating function can be used with or
without the flame effect.
5
PLEASE NOTE! Thanks to automatic operation,
the hot-air control (thermostat) maintains the pre-
programmed temperature at a constant level.
PLEASE NOTE! When you use the device for the
first time, a slight odour may occur.
] symbol switches

5.2 Overheat protection

For your safety, this device features overheating pro-
tection. If the temperature inside the device becomes
too high, it will switch off automatically. In this case,
proceed as follows:
For full heating power, switch on both heating
levels [ I ] and [ II ] using the on/off switches.
Heating level [ II ] only functions if the switch for
heating level [ I ] is also set to the [‒] symbol.
The temperature of the two heating stages can
be controlled using the thermostat 3 by setting
it between the [‒] and [+] settings. Turning the
thermostat 3 clockwise until you hear an audi-
ble click will switch on the device. [‒] represents
the lowest temperature (left) and [+] (right) the
highest temperature.
First, turn the thermostat 3 to the right in the
direction of the maximum value. Leave the
switch in this position until the air in the room
has reached your desired temperature.
+
GB/IE/NI/CY/MT 13