Information Concerning Disposal; Disposal Of Packaging; Disposal Of Your Old Appliance; Installing The Appliance - Thermador T24UW820RS Guide D'utilisation Et D'entretien

Information concerning disposal

Disposal of packaging

The packaging protects your appliance from
damage during transit. All utilized materials are
environmentally safe and recyclable. Please help us
by disposing of the packaging in an environmentally
friendly manner. Please ask your dealer or your local
authority about current means of disposal.

Disposal of your old appliance

Old appliances are not worthless rubbish! Valuable
raw materials can be reclaimed by recycling old
appliances.
WARNING:
1. Pull out the power plug.
2. Cut off the power cord and discard with the power
plug.
3. Remove the door from the appliance.
4. Do not allow children to play with the appliance
once it has spent its useful life. Danger of
suffocation!
Refrigerators contain refrigerant and gases in the
insulation. Refrigerant and gases must be recycled by
professionals. Ensure that tubing of the refrigerant
circuit is not damaged prior to proper disposal.

Installing the appliance

For detailed installation instructions, please refer
to the Installation Guide provided with the
appliance.
Have a technician install and connect the appliance
according to the enclosed installation instructions.
NOTE: For detailed installation instructions, relevant
measurements and information, please, see the
Installation Guide provided with this appliance.
WARNING:
Do not install this appliance:
- Outdoors
- In an environment with dripping water
- In rooms where there is a risk of frost

Transporting

The appliance is heavy and must be handled with
caution during transportation and installation.
Because of the weight and dimensions of the
appliance, at least two persons are necessary to move
the appliance into position securely and avoid injuries
to people or damage to the appliance.

Installation location

A dry, well ventilated room is suitable as an
installation location. The installation location should
not be exposed to direct sunlight and not placed near
a heat source, e.g. a cooker, radiator, etc.
If installation next to a heat source is unavoidable, use
a suitable insulating plate or observe the following
minimum distance from the heat source:
To electric or gas oven/range 1¼" (3 cm).
To an oil or coal-fired cooker 11
The floor of the installation location must not give
way; if required, reinforce floor. The appliance must be
upright to function correctly.

Ventilation

The refrigeration unit is ventilated only at the Toe-
Kick in the base. Never cover that area or place
anything in front of it. Otherwise the refrigeration
cooling performance will be affected and the unit must
work harder increasing power consumption.
Additionally, make certain all 4 leveling legs are
extended (unit height approximately
is sufficient airflow underneath the appliance.
Adjust all 4 legs to extend the appliance
height by approximately 1/2 inch.
13 " (30cm).
/
16
"), so that
5 | P a g e