LG WD-1259RD Manuel D'utilisation page 9

I nstallation
Normal Tap without thread & screw type inlet hose
1.
Unscrew the fixing screw to
attach the tap.
Upper
Connector
Rubber
packing
Fixing screw
Normal Tap without thread & one touch type inlet hose
1.
Un tighten the upper connector
screw.
Rubber
Upper
packing
Connector
Fixing screw
Middle
connector
• In case the diameter of the
tap is large remove the guide
plate.
Guide plate
Connector
Used the horizontal tap
Horizontal tap
Extension tap
Square tap
2.
Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
Rubber packing
Upper Connector
2.
Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then tighten
the 4 screws.
Rubber packing
Upper Connector
Middle connector
• Turn the middle connector not
to have water leaked.
• Make sure that the rubber
seal is inside the hose
connector.
Hose
connector
3.
Push the water supply hose
vertically upwards so that the
rubber packing within in the hose
can adhere completely to the tap
and then tighten it by screwing it
to the right.
Upper Connector
Water supply hose
3.
Connect the water supply hose to
the middle connector, pushing
the plate down.
Upper Connector
Water supply hose
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Rubber
seal
• Your machine comes with only
cold water connection.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
Plate
Plate
9