GE WSLP1500 Manuel D'utilisation Et D'installation page 20

Before you call for service...
Troubleshooting Tips
PERFORMANCE (cont.)
Snags, holes, tears, rips Pins, snaps, hooks, sharp
or excessive wear
Wrinkling
NOISE
Washer is noisy
Dragging noise prior
to water filling in
the tub
OTHER
Labels on the exterior
of the washer will not
peel off cleanly
20
POSSIBLE CAUSES
buttons, belt buckles,
zippers, and sharp objects
left in pockets
Undiluted chlorine bleach
Chemicals like hair bleach
or dye, permanent wave
solution
Improper sorting
Overloading or
incorrect water level
Repeated washing in
water that is too hot
POSSIBLE CAUSES
Washer is uneven
Washer load is
unbalanced
Washer is sitting too close
to wall (causes knocking
during cycle)
When using the LOAD
SENSING feature, the
agitator rotates before
water fills in the tub
POSSIBLE CAUSES
Occasionally the adhesive
used on the labels does
not release cleanly
WHAT TO DO
• Fasten snaps, hooks, buttons and zippers.
• Remove loose items like pins, objects in pockets
and sharp buttons.
• Turn knits (which snag easily) inside out.
• Check bleach package instructions for proper amount.
• Never add undiluted bleach to wash or allow clothes
to come in contact with undiluted bleach.
• Rinse items that may have chemicals on them before
washing.
• Avoid mixing heavy items (like work clothes) with
light items (like blouses).
• Try a fabric softener.
• Load your washer so clothes have enough room
to move freely.
• Wash in warm or cold water.
WHAT TO DO
• Level the washer. See Leveling the Washer.
• Press the START/PAUSE button to stop the washer, open
the lid and redistribute the load evenly. Close the lid
and restart.
• Pull washer away from the wall; about 4" is needed.
• This is normal.
WHAT TO DO
• Use a hair dryer set at the lowest heat setting, directing
the air at the label for a short amount of time. This will
release the adhesive easily, without damaging the surface
of the washer.