Metabo HPT M 1808DA Instructions De Sécurité Et Mode D'emploi page 20

English
4. LED light warning signals (Fig. 31)
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
activate during operation, the LED light will blink as
described in Table 5. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Safeguard Function
Overload Protection
Temperature Protection
NOTE
On occasion, about two seconds after stopping operation of the tool, the LED light will shut off and the power will
switch OFF.
This means that either the power is near empty or that the battery is overheated.
In such a case, allow the battery to cool and then recharge it for use.
20
Fig. 31
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
Table 5
Remove the cause of the overloading.
Allow the tool and battery to thoroughly
cool.
Corrective Action