Metabo HPT M 1808DA Instructions De Sécurité Et Mode D'emploi page 17

<Dust Collector Set>
Connect the dust collector set cleaner to collect dust.
(1) Slot the protrusion on the inside of the dust collector
to the positioning hole at the front lower left of the
base ass'y, and attach it to cover the front of the base
ass'y. (Fig. 25-a)
(2) Using the included knob bolt (D) to secure the dust
collector hole to the body's screw hole. (Fig. 25-b)
Positioning hole
Dust collector
Protrusion
OPERATION
WARNING
● To avoid a serious accident, press the power
button located on the switch panel to turn the
power OFF, and pull out the battery.
● Wear eye protection when operating this tool.
● Keep your hands, face and other body parts
away from the bits and any other rotating parts,
while operating the tool.
CAUTION
● To extend the lifetime, the lithium-ion battery
equips with the protection function to stop the
output. Therefore, if the tool is overloaded, the
motor may stop. However, this is not the trouble
but the result of protection function. In this case,
release the switch of tool and eliminate the
causes of overloading.
● Pull out the battery after completing operation.
Screw hole
a
Knob bolt (D)
b
Fig. 25
1. Switch operation
The unit will operate when the switch button is
pressed after pressing the power button. (Fig. 26)
See Fig. 27 for specifi cations on button controls.
The remaining battery indicator lamp and LED light
will always operate together with the power button.
If the power is ON and the tool is not operated
for approximately 10 seconds, the power will be
automatically switched OFF and the remaining battery
indicator lamp and LED light will also be switched off .
Power button
Switch button
Push
English
Remaining battery
indicator lamp
Push
LED light
Fig. 26
17