How To Set Video Stream Parameters - Urmet H.264 Guide Rapide De Configuration

5.3

HOW TO SET VIDEO STREAM PARAMETERS

The NVR manages three different stream videos for each camera associated to a channel:
Main stream: maximum resolution stream, used for video recording to hard disk and viewing on local network
Sub stream: medium/high resolution stream for remote viewing
Mobile stream: low resolution stream for remote viewing
To configure each stream open the web page of the NVR with Internet Explorer [Remote Setting
the stream to configure:
1. On the Main stream page, press the [Default] button and check that the factory default values are set.
Press [Copy] to copy the same values on all channels and press [Save] to save the parameters on the cameras.
2. On the Sub stream page, press the [Default] button and check that the factory default values are set.
Press [Copy] to copy the same values on all channels and press [Save] to save the parameters on the cameras.
3. On the Mobile stream page, press the [Default] button and check that the factory default values are set.
Press [Copy] to copy the same values on all channels and press [Save] to save the parameters on the cameras.
IMPORTANT: the default settings are those recommended for video streams to obtain a good trade-off between video
efficiency and fluidity for recording and live viewing in local and remote modes.
Different stream values from the default values illustrated above can be set manually.
DS1093-155A 42
Record] and select