The Remote Control - Husqvarna PP 492 Manuel D'utilisation

battery. The operation time of the remote control battery
also decreases if the display is on.
Dispose a damaged remote control battery at your
nearest service center or recycle it at an applicable
location.
Remove and install the remote control battery from the
rear side of the remote control.
To charge the remote control battery
CAUTION: Keep the charger of the remote
control battery dry and in protection against
temperature variation.
1. Connect the charger to a socket outlet.
2. Attach the remote control battery to the charger.
Make sure that the lamp on the charger comes on
and is orange.
3. Charge the remote control battery for approximately
2-3 hours to make it fully charged.
4. Remove the charger when the remote control battery
is fully charged and the lamp shows green.
10

The remote control

Use the "RETURN" button (A) to go back in the menu.
Use the arrow buttons (B) to move up and down in the
menus and the "OK" button (C) to do the selection.
OK
ON/OFF
0
Radio communication system
Before you can operate the connected power tool, you
must do a pairing operation between the remote control
and the power pack unit.
The remote control can only control the connected
power pack unit.
If the supplied remote control is replaced, you must do a
pairing operation between the remote control and the
power pack unit again.
If it is necessary to interchange the remote controls
between 2 power pack units, you must do a pairing
operation between the interchanged remote control and
the power pack unit.
To do a pairing operation between the remote control
and the power pack unit
1. Connect the remote control to the power pack unit
with the supplied CAN bus cable.
2. Tighten the cable connector screws by hand.
3. Wait until the remote control starts and the main
menu is shown on the display.
OK
ON/OFF
0
A B C
967 - 001 - 04.02.2020