Husqvarna PP 492 Manuel D'utilisation page 10

Main menu Submenu
9. "RUN TIME"
10. "TIME & DATE"
11. "LANGUAGE"
2. "SETTINGS"
12. "SET UNITS"
13. "PAIR RADIO"
14. "RADIO CHAN-
NEL"
3. "SERVICE"
15. "CALIBRATE ARM"
16. "SET BLADE DIAMETER"
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do daily maintenance. Refer to
on page 14 .
3. Make sure that only approved persons are in the
work area, because there is a risk of serious injury.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
Remote control battery
Note: You must charge the remote control battery before
you use the remote control for the first time.
967 - 001 - 04.02.2020
Adjustment
• "TIME COUNTER" - A stop monitor counts the time that the blade or
the wire rotates during the operation when minimum 1 supply is on.
• "CLEAR RUNTIME" - Releases the stop monitor.
• "CURRENT RUNTIME" - Shows the current run time.
• "SET TIME" - Set the current time.
• "SET DATE" - Set the current date.
• "TIME FORMAT" - Select time format:
• 12h
• 24h
• "DATE FORMAT" - Select date format:
• "YYYY-MM-DD"
• "YYYY/DD/MM"
• "DD/MM/YYYY"
Select display language.
Select unit for the remote control:
• "AMERICAN"
• "METRIC"
Connect the remote control with the product.
If the operator experiences interference or loss of signal, the radio chan-
nel for the remote control and the power pack unit must be changed. To
set up the radio channel, the remote control must be connected to the
power pack unit with a CAN bus cable. Select the correct radio channel:
• 0 (2.410 GHz)
• 1 (2.415 GHz)
• ...
• 11 (2.465 GHz)
The "SERVICE" menu is locked by password. Only servicing personnel
have access to do the adjustment in the "SERVICE" menu.
The calibrate menu is used to calibrate the position of the pivot arm. Use
the position of the pivot arm to calculate the current depth of the blade.
The blade diameter adjustment is used to calculate the depth of the
blade.
Daily maintenance
The remote control battery is a Li-ion battery. Use only
original batteries for this product. Refer to an approved
dealer for more information.
A fully charged remote control battery can operate
maximum 8-10 hours. Cold weather decreases the
capacity and the operation time of the remote control
9