Installation Of The Indoor Unit - Daikin FWF02AATNMV1 Manuel D'installation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Disposal requirements

Your air conditioning product is marked with this symbol. This means that electrical and electronic products shall not

be mixed with unsorted household waste.

Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatment of the refriger-

ant, of oil and of other parts must be done by a qualified installer in accordance with relevant local and national

legislation.

Air conditioners must be treated at a specialized treatment facility for re-use, recycling and recovery. By ensuring this

product is disposed of correctly, you will help to prevent potential negative consequences for the environment and

human health. Please contact the installer or local authority for more information.

Batteries must be removed from the remote controller and disposed of separately in accordance with relevant local

and national legislation.

1. Preliminary Site Survey

Obstacle

• Electrical supply and installation is to conform to local authority's (e.g. National Electrical Board) codes and regulations.

• Voltage supply fluctuation must not exceed ±10% of rated voltage. Electricity supply lines must be independent of welding

transformers which can cause high supply fluctuation.

• Ensure that the location is convenient for wiring, piping and drainage.

• The indoor unit must be installed in such that is free from any obstacles in path of cool air discharge and warm air return, and

must allow spreading of air throughout the room (near the center of the room).

• Provide clearance for the indoor unit from the wall and obstacles as shown in the figure.

• The installation place must be strong enough to support a load 4 times the indoor unit weight to avoid amplifying noise and

vibration.

• The installation place (hanging ceiling surface) must levelled and the height in the ceiling is 350mm or more.

• The indoor unit must be away from heat and steam sources (avoid installing it near an entrance).

2. Unit Installation

15.0

32.0

580.0 ~ 610.0 mm (Ceiling Board Opening)

• Measure and mark the position for the hanging rod. Drill the

hole for the angle nut on the ceiling and fix the hanging rod.

• The installation template is extended according to tempera-

ture and humidity. Check on dimensions in use.

• The dimensions of the installation template are the same as

those of the ceiling opening dimensions.

• Before ceiling laminating work is completed, be sure to fit

the installation template to the indoor unit.

Note: Be sure to discuss the ceiling drilling work with the in-

stallers concerned.