TDK-Lambda DRF480 Série Mode D'emploi page 20

PA620-04-01B
12. Connections
CN17
Signal Connector Information
Signal connector used (CN17)
Part Description
Pin Header S8B-PHDSS(LF)(SN)
Matching Housings, Pin & Tool
Part Description
Socket Housing
Terminal Pins
Hand Crimping YRS-620(SPHD-002T-P0.5)
Tool YC-610R(SPHD-001T-P0.5)
Signal Connector Pin Assign
S8B-PHDSS(LF)(SN) (JST)
2 1
4 3
5
6
8 7
13. DRF480 series UL508 Listed Condition
WIRING
Connector Recommended Wire
Input
10~24 AWG
(L, N, )
Output
10~24 AWG
(+V, -V)
Output
10~24 AWG
(DC OK)
Trimmer adjustment
is strictly prohibited.
Part Name Manufact.
JST
Part Name Manufact.
PHDR-08VS
SPHD-002T-P0.5
SPHD-001T-P0.5
1. CB
2. CB_COM
3. NC
4. NC
5. CNT+
6. CNT-
7. PV
8. COM
Max. Torque
10.3 kgf.cm
(9 lbf.in)
10.3 kgf.cm
(9 lbf.in)
10.3 kgf.cm
(9 lbf.in)
1) Wire requirements, use minimum 75°C wire, use copper
conductor only.
2) For use in a Pollution degree 2 environment only.
3) These products are considered for use where maximum
surrounding air temperature does not exceed 70°C. When
installing these products, please refer to section 9 for
derating.
4) Indoor use only.
14. DRF480 series ATEX/IEC Ex Conditions
(Model DRF480-24-1/HL-xyz only)
II3G Ex nA nC IIC T3 Gc
The DRF480-24-1/HL is a sub model of the DRF480 series.
It has the same functionality as the standard DRF480 and
benefits from a conformal coating. It is suitable for
applications in Zone 2 provided it is installed in an
JST
appropriate IP54 enclosure according EN60079-15. When
fitted in an IP54 enclosure, mounting method (section 8),
JST
ambient temperature requirement and deratings (section 9)
must be complied with. Do not adjust any trimmers when
JST
explosive atmosphere could be present.
The DRF480-24-1/HL is approved to IEC/EN60079-0 and
IEC/EN60079-15 Protection type nA and nC.
The product is suitable for IIA, IIB and IIC gas atmospheres.
Temperature class T3 (maximum surface temp ≤ 200°C).
Product marking:
TDK-Lambda UK Ltd
Kingsley Avenue, Ilfracombe
Devon, EX34 8ES
Telephone - Sales and Service +44 (0)1271 856666
Head Office and Works +44 (0)1271 856600
Facsimile +44 (0)1271 864894
WEBSITE: www.uk.tdk-lambda.com
TDK-Lambda
DRF480 Series
INSTRUCTION MANUAL