Preventing Equipment From Falling Over - Pioneer PDK-FS07 Mode D'emploi

Preventing equipment from falling over

After installing the stand, be sure to take special care to ensure that the Plasma Display will not fall over.
• Because of the Plasma Display's weight, if it could fall down,
this can result in injury.
• For safety, be sure to take special care to ensure that the
Plasma Display will not fall over.
1
Attaching falling prevention bolts to the Plasma
Display.
2
Using strong cords to stabilize it appropriately and
firmly to a wall, pillar, or other sturdy element.
• Perform this work in the same way on the left and right
sides.
• The length of the cords used must be long enough to allow
the stand to rotate freely.
Note
Use falling prevention bolts, ropes and
fittings that are available on the market.
Recommended bolts:
Nominal diameter M8
Length 12 mm to 15 mm (1/2 inch to
5/8 inch)
1
Falling prevention bolts
2
Cord
Fitting
• An area of the floor with adequate strength should always be
• When installing the Plasma Display, please take the
• If you do not take these precautions, the Plasma Display
• The screws, hooks and other fittings that you use to secure
• Select the appropriate screws, hooks and other fittings after
12 mm to 15 mm
(1/2 inch to 5/8 inch)
Caution
used to support the Plasma Display.
Failure to do so could result in personal injury and physical
damage.
necessary safety measures to prevent it from falling or
overturning in case of emergencies, such as earthquakes, or
of accidents.
could fall down and cause injury.
the Plasma Display to prevent it from overturning will vary
according to the composition and thickness of the surface to
which it will be attached.
first inspecting the surface carefully to determine its
thickness and composition and after consulting a
professional installer if necessary.
7
En