Table Des Matières; Cautions; Important Notice; Installation Location - Pioneer PDK-FS07 Mode D'emploi

Thank you for buying Pioneer's product.
Please read through the Operating Instructions to learn how
to operate your model safely and properly.
Please be advised to keep the Operating Instructions in
your place for future reference.

IMPORTANT NOTICE

Record the model number and serial number of this
equipment below.
Model No. PDK-FS07
Keep this number for future use.
WARNING
To prevent a fire hazard, do not place any naked
flame sources (such as a lighted candle) on the
equipment.
Installation
¶ Consult your dealer if you encounter any difficulties
with this installation.
¶ Pioneer is not liable for any damage resulting from improper
installation, improper use, modification, or natural disasters.
Contents
Cautions ................................................................... 2
List of parts and equipment included ................... 3
Installation and assembly instructions ................. 4
Preventing equipment from falling over ............... 7
Specifications .......................................................... 8
Dimensions diagram ............................................... 8
This symbol refers to a hazard or unsafe practice which
can result in personal injury or property damage.
2
En
Serial No.
D3-4-2-1-7a_A_En
CAUTION

Cautions

This product is a floor stand exclusively designed for
Plasma Displays (PDP-507XD / PDP-507XA / PDP-507XG /
PDP-507XDA / PDP-427XD / PDP-427XA / PDP-427XG /
PDP-427XDA / PDP-4270XD / PDP-4270XA) from Pioneer.
Note that it is not designed for use with any other equip-
ment. For further information, please contact the store
where you purchased your display.
Do not install or modify the product other than specified.
Do not use this stand for a Plasma Display other than those
designated and do not modify it or use it for other
purposes.
Improper installation is extremely dangerous because it
may result in it falling over or other accident.

Installation Location

• When selecting the location in which the stand is to be
placed, be sure to select a location with a surface
sufficiently strong to bear the weight of the stand and
Plasma Display. (Product weight is listed on page 8)
• Make sure the installation location is a level, flat, and
stable surface and take proper precautions when
installing it to make sure its weight is evenly distributed.
• Depending on the type of surface on which the stand is
placed, the legs may leave marks on the surface, and this
should be taken into consideration when selecting the
place in which the stand is to be placed.
• Do not install it outdoors, at a hot spring, or near a beach.
• Do not install the stand where it may be subjected to
vibration or shock.
Assembling and Installation
• Assemble the stand in accordance with the assembly
instructions and securely attach all screws at the
designated locations.
There have been cases where unforeseen accidents
such as the equipment breaking or falling over
occurred after the installation of the display because
the stand was not installed as instructed.
• The display must always be installed by two or more
people to assure it is installed safely.
• Before installation, turn off the power for the display
and peripheral devices then remove the power cord
plug from the power outlet.

After Installation

• Never lean on the Plasma Display or apply heavy pres-
sure to the stand.
• Prevent accidents caused by the product falling over by
taking reliable measures to prevent it from falling over
(see page 7).
• Do not move the stand with the Plasma Display etc. still
attached.