Names And Functions Of Parts (Main Unit) - Esoteric Grandioso D1 Mode D'emploi

Names and functions of parts (main unit)

A
POWER button
Use to turn the unit on and off.
When the unit is on, the ring around this button lights blue.
When the unit is off, it is unlit.
Turn the unit off when not using it.
B
CLOCK indicator
This shows the clock synchronization status.
Lit blue
When the clock setting uses any synchronization other than
PLL (CLK>OFF), the indicator blinks blue while the clock signal is
being detected. The indicator stops blinking but stays lit when
the signal is confirmed and synchronization starts.
Lit green
This lights when the unit is operating with the built-in oscillator
during USB input.
C
MENU button
Use to enter setting mode (page 12).
D
Remote control signal receiver
This receives signals from the remote control. When using a
remote control, point it toward this receiver when operating it.
o This unit does not include a remote control.
o The dimmer of this unit can be adjusted using a remote con-
trol included with a P1 or other Esoteric product (page 16).
10 10
A B C D E F
E
Display
This shows information about the selected input connector, for
example.
F
INPUT selection button
Use to change the digital input. Select a connector that has
a digital source device connected. If no digital signal is being
input, no sampling frequency will be shown to the right of the
word "INPUT" on the display.
G
Parameter adjustment buttons (−/+)
Use to change parameters when in setting mode.
o You cannot change the volume with this unit.
G