Features And Specifications; Power Output - Jensen power 4002 Manuel D'installation Et D'utilisation

FEATURES AND SPECIFICATIONS

Your new Jensen Power mobile stereo power amplifier is the amplifier of choice for the high
demands of auto sound reproduction. With its deep-bass reproduction and plenty of reserve
power, low harmonic distortion and neutral reproduction, the Power series of amplifiers takes
Mobile Hi-Fi to new heights. Like all Jensen products, when it comes to accurate sound
reproduction the Power series takes a back seat to no one. Jensen will bring your Hi-Fi
experience to new heights with the following features:

MOSFET Power Supply

High Current Bi-Polar Output Transistors

Optimized Class AB Design Minimizes Distortion and Reduces Idle Current

Easily Drives 2-Ohm Loads

Pass-Thru RCA's

Variable Bass EQ 0 - 12dB @ 45 Hz

12dB / Octave Low Pass and High Pass filters

Variable Input Level 400mV - 5V

Short Circuit, DC-offset and Thermal Overload Protection Circuitry

Diagnostic LED's - Green: Power, Red: Standby / Fault
Power 4002 / 760

Low Pass Filter 40 - 300 Hz

High Pass Filter 40 - 300 Hz

High Pass / Low Pass / Full Range Selector Switch

Stereo / Mono Mode Switch (Power 4002 only)

2/ 3 / 4 Channel Mode Switch (Power 760 only)
Power 900.1

Mono Subwoofer Amp

Low Pass Filter 40 - 300 Hz (Power 900.1)

Subsonic Filter 10 - 40 Hz, 12dB / octave (Power 900.1)

Remote Input Level Control (Remote Bass Control) with 5 Meter Interface

Cable
Specifications
Power 4002 / 760

Load Impedance: 2 / 4-Ohm

Signal to Noise @ 1 kHz: >100dB (rated power)

Channel Separation @ 1 kHz: >60dB

Frequency Response: 10-60 kHz, -3dB

Input Impedance: 20 kHz, nominal

THD+N @ 1 Watt: 0.02%, 1 kHz, 14.4VDC
Power 900.1

Signal to Noise @ 120 Hz: >100dB (Rated Power)

Channel Separation Not Applicable

THD+N @ 1 Watt: 0.02%, 125 Hz, 14.4VDC

Power Output


RMS Power Output @ 2% THD+N, 1kHz, 14.4VDC
Power 4002

75 x 2 Watts, 4-Ohm

100 x 2 Watts, 2-Ohm

200 x 1 Watts, 4-Ohm Bridged
Power 760

75 x 4 Watts, 4-Ohm

100 x 4 Watts, 2-Ohm

190 x 2 Watts, 4-Ohm Bridged Stereo
Power 900.1

300 x 1 Watts, 4-Ohm

450 x 1 Watts, 2-Ohm
Specifications subject to change without notice.
3
POWER Amplifiers