Publicité
Les langues disponibles
Les langues disponibles
- Select the appropriate support (
outer diameter (diameter of support
diameter).
- During removal, the bearing must slide inside the support (
- Select the appropriate centring device for supports (
according to the selected support (
- Assemble the screw (
the nut (
) (fig. 2).
H
- Begin to remove as shown in fig. 3. You can monitor the progress
of operations through the slot on the supports. Figure 4 shows the
completion of the removal procedure.
WHEEL BEARINGS ASSEMBLY
Identify all the required pieces and assemble the tools as follows:
- Measure the inner and outer diameter of the bearing
- Identify the appropriate bearing pressure ring
(
).
B
• Diam. of pressure ring
• Diam. of centring bearing
- Mount the selected tools (
(fig. 1).
- Select the appropriate support (
outer diameter (diameter of support
diameter).
- Select the appropriate centring device for supports (
according to the selected support (
- Assemble the screw (
the nut (
) (fig. 2).
H
- Insert the new bearing as shown in figure 6.
Always check that the bearing is in the correct
position during insertion: it is essential that the
bearing be centered when inserted. WÜRTH
disclaims any liability arising from misuse of its
tools.
WHEEL HUB ASSEMBLY
Identify all the required pieces and assemble the tools as follows:
- Identify the appropriate pressure ring
WARNING: the diameter of the selected pressure
ring must be greater than the bearing's seat.
14
) according to the bearing's
D
> wheel bearing
D
).
D
) the nut with the bearing (
E
centring ring
A
= bearing outer diameter
A
= bearing inner diameter
B
and
) on the adapter (
A
B
) according to the bearing's
D
> wheel bearing
D
).
D
) the nut with the bearing (
E
.
A
4
).
D
)
F
) and
I
5
)
C
6
)
F
) and
I
7
Publicité
