SEVERIN KA 5978 Mode D'emploi page 15

nozzle in such a way that the frother is
just submerged in the milk.
∙ Turn the rotary control to the
The steam nozzle is now open.
∙ Turn the jug with a circular motion for
around 40-45 seconds.
∙ Once the milk is suffi ciently frothy, turn
the control back to the espresso symbol
( ) to continue the espresso cycle.
∙ Once the espresso is ready, place a
suitable container under the steam nozzle
and turn the rotary control to the
position. Wait until steam is no longer
emitted.
∙ Use a spoon to spread the milk froth over
the espresso. The proper ratio should be
1/3 espresso, 1/3 hot milk and 1/3 milk
froth.
Separate steam function
∙ Fill the glass jug with water to the lower-
level mark and pour it into the water
container.
∙ Pour the milk to be frothed (or other
beverage to be heated) into a suitable
heat-resistant jug (fi ll jug to one half
max.).
∙ To froth milk, the frother must be fi tted to
the steam nozzle.
∙ Position the jug underneath the steam
nozzle or milk frother in such a way that it
is just under the surface at all times.
∙ Turn the rotary control to the steam
symbol ( ).The steam nozzle is now
open.
∙ After a brief heating period, steam will be
emitted.
∙ Turn the jug with a circular motion for
around 40-45 seconds.
∙ Once the steam function is no longer
required, place a suitable container under
the steam nozzle and turn the rotary
control to the
position. steam is no longer emitted.
Cleaning and care
∙ Remove the plug from the wall socket and
wait until the appliance has cooled down.
∙ To clean the steam nozzle each time
after use, place a suitable container
underneath it and turn the rotary control
to the
pressure inside the water container and
clean the steam nozzle at the same.
∙ Wipe off the milk frother with a damp cloth
once it has cooled down. It should be
frequently removed for thorough cleaning;
ensure, however, that the appliance has
suffi ciently cooled down before the frother
is removed and cleaned with hot soapy
water. To remove any remaining water
from the water container, wait until the
appliance has cooled down, remove all
other accessories and unscrew the lid.
Pour out the water through the water fi ll
opening.
∙ To avoid the risk of electric shock, do
not clean the appliance with liquids or
immerse it.
∙ Do not use abrasives or harsh cleaning
solutions.
∙ The exterior housing may be wiped with a
damp, lint-free cloth.
∙ The glass jug, fi lter holder, fi lter insert and
drip tray may be cleaned in warm water
using a mild detergent; do not clean
these parts in a dish-washer.
Descaling instructions
Depending on the water quality (lime content)
in your area as well as the frequency of use,
all thermal household appliances using hot
position. Wait until
position. This will release the
15