Roller Grill RFG 16 C Notice D'installation Et D'utilisation page 18

The heat release rate of the appliance is
The gas consumption is of :
For a use in natural gas, change the injectors of the burner. They are delivered in a
small plastic bag placed in the package.
To change the burner injector, unscrew the two screws placed on the front part and
remove the knob. To set the natural gas pilot light injector, unscrew the injector of a
half turn.
Connect the appliance to the gas supply pipe, interposing a stop valve which enables
the appliance to be insulated from the rest of the installation.
Check the supply pressure using a manometer when all the burners are lit. It must be
equal to the indications on the rating plate.
This appliance must be installed with a sufficient ventilation to prevent the forming of
concentrations of harmful substances.
The fresh air flow required for combustion air supply is:
- RFG 16 C 24.45 m3/h
General conditions of installation
We remind you that it is recommended to call on an qualified installer qualified to set
up this appliance and if necessary to adapt it for the natural gas using.
Parts sealed in factory must not be handled neither by the installer nor the user.
The installation and maintenance of the appliance must be carried out in compliance
with the statutory texts and good practices in force, mainly:
General specifications
For all appliances:
Article GZ Installation with combustible gases and liquefied hydrocarbons.
Then, according to use:
Article CH Heating, ventilation, refrigeration
Air conditioning and domestic hot water steam generation.
Article GC Installation of appliances to be used for catering
Specific provisions for each type of establishment to which the public is admitted
(hospitals, shops, etc )
Important: Never change the diameter of the injectors.
RFG 16 C
1268 l/h with G20 and 1598 l/h with G25
946 g/h with G30 and 1086 g/h with G31
12 kW with G30/G31
12 kW with G20/G25
18