First Start And Internet Connection - elco REMOCON NET Notice Technique D'installation Et D'entretien

First start and internet connection

Gateway fixing on a flat surface
Once all the electrical connections
between the gateway, the ther-
moregulation accessory and the
ELCO heating product is made, it
is possible to finish the installation
by attaching the gateway to a wall
or to other vertical supports. The
gateway is water protected IP
X4D, however it is not recom-
mended to install in weathered
positions or subject to other exter-
nal factors that could cause dam-
age. The gateway can be installed
on a smooth surface using the ad-
hesive or, alternatively, using the
supplied screws for the wall plate.
First start and internet connec-
tion
In this chapter it is described how
to connect the REMOCON NET
system to internet, through two
different procedures depending on
whether a ADSL or GPRS gate-
way version is used.
Internet connection
ADLS router
REMOCON NET can communi-
cate with an ADSL router using a
LAN cable or Wi-Fi connection. In
the latter case, please skip to step
2 of the following procedure.
 With REMOCON NET switched
OFF and not connected to the
power line, open the front panel,
connect the LAN cable (max.
90Meter) to its connector and
close the panel.
 Power supply the gateway and
press the ON/OFF button. For
few minutes the gateway per-
forms its start-up procedure,
during all LEDs will flash a blue
sequence. At its conclusion, the
WEB led remains fixed red,
while the BUS (and SERIAL,
depending on the installation)
remains fixed green.
Note: before fixing the gateway to
the wall, we recommend that all
electric connections and the prod-
uct configuration have to be com-
pleted.
ATTENTION!
Before applying the biadhesive, we
recommend to carefully clean the
support.
3. Press and hold the start-up but-
through
ton for at least 5 seconds, until
the WEB led start to fl ash a
green light. At this point the gate-
way has created a new Wi-Fi
access point that will be kept
active for 10 minutes. After this
time elapsed, it will be possible –
if necessary – to repeat the pro-
cedure.
4. Open the network settings of
your personal internet device
(smartphone, pc, tablet..) and
search for new Wi-Fi networks
available. Select the Remote
GW Thermo network.
5. Once your device is connected
to this network, open the web
browser (Explorer, Chrome, Fire-
fox...) and go to the following
link:192.168.1.1
6. Follow each step of the direc-
tions given in the web browser to
connect REMOCON NET with
ADSL router.
7. Wait until the WEB led on the
NOTE:
REMOCON NET is compatible with
the following Wi-Fi security set-
tings:
- WEP
- WPA/WPA2 Personal
Note:
In case of failure (WEB led red),
repeat the above procedure start-
ing from point 3. The process must
be repeated any time a change has
made on the Wi-Fi line present in
the dwelling, or in case there is a
switch between Wi-Fi and ADSL
connection.
Suggestion:
If the Wi-Fi signal is weak and is
not possible to use a LAN commu-
nication, it is possible to use a Wi-
Fi repeater, available on many con-
sumer electronics stores
27
gateway make a quick green
flash. If the procedure has been
successful, the WEB led will re-
mains green