ION PURE LP Guide D'utilisation Rapide page 5

TROUBLESHOOTING
If you experience any difficulties, please refer to the troubleshooting steps below as well
as those in the EZ Vinyl/Tape Converter manual included with this product.
If you are recording to a computer:
o Make sure that PURE LP is powered on and that the needle is on the record.
o Make PURE LP is selected as your computer's default recording device (see the instructions below).
o If you are listening through your computer's speakers, make sure those speakers are selected as your
computer's default playback device (see the instructions below). Alternatively, you could connect PURE
LP's RCA outputs to a stereo system or powered speakers. Do not connect them to phono-level inputs;
PURE LP's RCA outputs are line-level and could damage a device with phono-level inputs.
(Note: The RCA outputs monitor the signal coming out of the turntable, not the signal coming from your
computer.)
o Disconnect then reconnect the USB cable connecting PURE LP to your computer.
I'm not hearing any audio when playing music:
• If you are playing music from vinyl:
o Make sure that PURE LP is powered on and that the needle is on the record.
o Connect PURE LP's RCA outputs to a stereo system or powered speakers. (Do not connect them to
phono-level inputs; PURE LP's RCA outputs are line-level and could damage a device with phono-level
inputs.)
• If you are playing music from your computer:
o Make sure your software music player's volume is turned up.
o Make sure your computer's volume is turned up.
o Make sure your computer's speakers are selected as your computer's default playback device (see the
instructions below). (PURE LP cannot be used as a playback device for your computer's audio.)
I am hearing a Hum through my speaker or laptop when using the turntable:
• If you are recording to a laptop:
o Please connect the laptop to a grounded power supply (3 prong)
• If you are playing through a speaker:
o Please connect to a grounded (3 prong) power supply.
SETTING YOUR COMPUTER'S SOUNDCARD AS THE DEFAULT PLAYBACK DEVICE
• Windows XP: Click Start Menu
Audio Devices. Click the Audio tab and under Sound playback, select your computer's soundcard as the
default device.
• Windows Vista: Click Start Menu
and Sound Sound. Click the Playback tab and select your computer's soundcard as the default device.
• Windows 7: Click Start Menu
soundcard as the default device.
• Mac: Click the upper-left "apple" icon then click System Preferences
menu, select Internal Speakers if you are using the computer's internal speakers or select Headphones if you
are using speakers or headphones attached to the computer's 1/8" headphone output.
SETTING PURE LP AS THE DEFAULT RECORDING DEVICE
• Windows XP: Click Start Menu
Audio Devices. Click the Audio tab and under Sound recording, select PURE LP as the default device.
• Windows Vista: Click Start Menu
and Sound Sound. Click the Recording tab and select PURE LP as the default device.
• Windows 7: Click Start Menu
the default device.
• Mac: Click the upper-left "apple" icon then click System Preferences
menu, select PURE LP as the device.
BEFORE RETURNING THE PRODUCT, please contact ION Audio or your retailer for
technical support. Contact information can be found in the Safety Instruction Booklet
included with this product.
Control Panel (or Settings
Control Panel (or Settings
Control Panel Sound. Click the Playback tab and select your computer's
Control Panel (or Settings
Control Panel (or Settings
Control Panel Sound. Click the Recording tab and select PURE LP as
www.ionaudio.com
5
Control Panel in Classic View)
Control Panel in Classic View)
Sound. Click the Output tab. From the
Control Panel in Classic View)
Control Panel in Classic View)
Sound. Click the Input tab. From the
Sound and
Hardware
Sound and
Hardware