FEATURES
1.
Platter – Place your record
here.
2.
Counterweight – Controls
how much weight is applied
to the tonearm. If the tonearm
is skipping over the record
during playback, try adjusting
this counterweight by turning
it so it moves more "into" the
tonearm. This places more
weight on the cartridge to
help prevent it from lifting off
of the record.
3.
Tonearm – The tonearm can
be raised and lowered by
hand, or by pressing the raise
/ lower lever. Please note that
the tonearm needs to be
moved away from resting
position (on the arm clip) for
the
turntable
activate. When the tonearm
is placed back in its resting
position, the turntable motor
will deactivate.
4.
Arm Clip – This specially designed arm
clip secures the tonearm while at rest or
when not in use. The arm clip has been
designed to remain in the up position
while unlocked.
5.
Raise / Lower Lever – Raises and lowers the tonearm.
6.
33 / 45 / 78 Switch* – This switch controls the RPM of
the turntable platter.
7.
Autostop switch – This switch turns autostop on or off.
When autostop is on, the platter will start spinning when
the tonearm is placed over the record and stop spinning
when the record has reached the end. (When autostop
is off, the platter will always spin regardless of the
position of the tonearm.)
8.
RCA Output** – The audio from a playing vinyl record
is sent to this line-level coaxial audio output. This must
not be connected to phono level devices.
9.
USB Audio Output – Use the included USB cable to
connect your turntable to your computer. The USB
connection will send audio from the turntable to your
computer. Please see the USING PURE LP WITH
YOUR COMPUTER section of this manual for
information.
10.
Power – Use the included adapter to connect to wall power.
11.
Power Button – Press this button to turn PURE LP on/off.
motor
to
PURE LP
Mac/PC
7 1
8
9
IMPORTANT:
cartridge cover (needle cover) before
operating the turntable.
* If needed, you may adjust the speed of
the turntable platter. On the underside of
PURE LP, remove the rubber pads and
tighten/loosen the appropriate screw with
a screwdriver.
**WARNING: The RCA outputs are LINE
level. Please only connect these to LINE
level inputs. You may damage your
receiver if you plug in a LINE level device
into a PHONO level input.
4
7 3
7 4
11
10
Remove
the
plastic
7 2
7 5
7 6
7 7