Note: Do not use resinous and sticky Essential oils (Myrrh, Frankincense, Patchouli ...) in
this unit. Essential oils of citrus and conifer (pine, fir ...) can be used if take care of the
nebulizer by cleaning completely the unit after use.
Cleaning the ceramic disk and water sensor level:
Clean the ceramic disc and the surface of the nebulizer with soft cloth or cotton sticker
with some white vinegar, leave it for a few minutes. Then rinse with clean water.
Do not press or scratch the ceramic disc or the water lever sensor.
Don't use washing powder, soap, solvent, or spray to clean any part of the nebulizer.
Do not use hard tool to scratch the surface.
To clean the vase:
Clean the glass vase with a non-corrosive product and then rinse with clean water.
Storage:
After having cleaned and dried the diffuser, store it in a clean, dry place, out of the reach
of children.
Note:
The lifetime of the ceramic disk is limited (about 2000 hours). After some time of
utilization the device will generate less mist. This is normal wear of the ceramic disk. It
should be replaced by the same size of ceramic disc (replacement ceramic disk not
included).
Please obtain this item and the appropriate tool from your local dealer and see the
explanation below.
A. Unplug the unit and remove the water from the vase.
B. The interior of the unit must be completely dry before the parts are installed.
C. Insert the tool for ceramic disk in the threaded ring and turn clockwise to clockwise. This
tool is provided with the replacement ceramic disk.
D. Remove the threaded ring and the used ceramic disk.
IMPORTANT, please note all parts need to be installed in the right order (for the ceramic
disk, the dark circle side should be the down side).
Winding Ring
Ceramic Disc
Sealing Washer
Front Of
Tool
Ceramic Disc
Mist Cavity
Behind Of
Ceramic Disc
Water Lever
Sensor Switch
LED Lamp
Rubber Tuck
EN
13