User Rules; What Shouldn't Be Done - Cassese CS969 Manuel D'utilisation

USER MANUAL

USER RULES

Saw CS 969 is a machine used to cut 45° mitres on all mouldings with solid or reconstituted wood base, and with or without coating
(paint, varnish, plastic coating, paper, etc.).
Are excluded :
•
Mouldings that don't have a 90° angle back on at least 5mm,
•
Metal profiles,
•
Small plastic profiles (filets, etc...).
Its two circular blades are driven by two electric motors.
The moulding is held automatically by vertical and horizontal pneumatic cylinders.
A two-hand control, actuating both clamping and cutting, ensures operator safety by keeping hands out of range of the blades.
The electrical control equipment is placed in a cabinet in front of the machine and on the right side.
The pneumatic equipment is secured in the base of the machine behind the electrical cabinet.
This machine was built to meet safety and hygiene requirements. It is therefore forbidden to modify the electrical and pneumatic
equipment, remove protective equipment installed on delivery or modify the machine safety devices.
Saw CS 969 cannot be used by more than one operator at a time.
To prevent electric shocks and overload, some protections should be installed by the user on the electric supplying line to the machine,
EN60204-1 :2006, Article 7
according to

WHAT SHOULDN'T BE DONE

- At no time the operator should engage his hands in the clamp area, nor in the cutting area behind the brushes. (blades are rotating
even when returned to the back position)
- Do not use steel blades (HS type)
- Prior to any maintenance operation, switch off electric and pneumatic supply by using and locking their switches. (14 & 16, Page 11).
- Switch off the machine by using the electric contactor on the right side of the machine and lock it with a padlock.
- Only one person at a time should use the machine. This person is responsible for the controls.
- All adjustments should be performed with the cover closed. At no moment the operator should put his hands inside the covers. This
measure is intended to guarantee the safety of the operator, who should under no circumstances insert his hands inside the cover.
- If none of the clamps can hold the mouldings, the cut of that moulding is forbidden.
- Do never use the machine with a missing panel.
- These particular mouldings cannot be cut on the CS969.
CS969
9