Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
8.A.d Closing the main case
Close the main case to its lowest position.
Engage the snap and lower the locking levers of SD and SG.
Then, remove the padlocks from the main switch 16 and the valve 14 (page: 25), reset the main switch 16 and turn the red button
on the valve 14. Lock the cover by putting the key on machine ready
8.A.e Replacing the martyr cube
For all maintenance, adjustment or repair operations, prevent unintentional operation of electrical and
pneumatic circuits on the machine by padlocking the main isolating switch 16 and the valve 14 (page 11).
Allen key 2
Inside the machine
Open the main case
(see page 35)
Remove the used
martyr
cube
by
pulling it verticaly
Put it back in its
housing and fix it
with the screw V1
Figure 8-6
Figure 8-8
Figure 8-10
Unscrew the screw
V1 with Allen key 2
V1
Turn
the
martyr
cube of 180°
Check
the
good
level with the table
CS969
Figure 8-7
Figure 8-9
Figure 8-11
37
Publicité
Table des Matières
