Complementary Safety Instructions For Hedge Trimmers - FLORABEST FBK 4 A1 Traduction Du Mode D'emploi D'origine

–
If the petrol has overflowed, do not attempt to start the engine. Remove
GB
the machine from the fuel-contaminated area before restarting.
IE
–
Always replace the filler cap after refuelling and close it securely.
–
If the tank is empty, this should be done in the open.
g) If the cutting unit comes in contact with a foreign object or if the operating
noise increases or the hedge trimmer starts to vibrate abnormally, stop
the engine and allow the hedge trimmer to come to a standstill. Pull the
spark plug connector off the spark plug and take the following action:
–
check for damage;
–
check for loose parts and secure all the loose parts;
–
replace damaged parts with equivalent parts or have them repaired.
Wear ear protection!
Wear safety goggles!
■ Familiarise yourself with the operation of the hedge trimmer so that you
know how to stop immediately in an emergency.
Operation
a) The engine is to be immobilised before:
–
cleaning or removal of a blockage;
–
inspection, maintenance or work on the hedge trimmer;
–
setting the working position of the cutting unit;
–
if the hedge trimmer is to be left unattended.
b) Always make sure that the hedge trimmer is in the proper working posi-
tion before the engine is started.
c) During operation of the hedge trimmer, always ensure that you have firm
footing, especially when using a ladder.
d) Do not use the hedge trimmer if it has a defective or badly worn cutting
unit.
e) To minimise the risk of fire, ensure that the engine and the silencer are
free of residues, leaves or leaked lubricant.
f) Ensure that all supplied handles and safety guards are mounted when
operating the hedge trimmer. Never attempt to operate an incompletely
assembled hedge trimmer or a hedge trimmer with non-approved modi-
fications.
g) Always use both hands if the hedge trimmer is equipped with two
handles.
h) Always familiarise yourself with your environment and be aware of potential
dangers that you may not be able to hear because of the noise of the
hedge trimmer.
Maintenance and storage
a) If the hedge trimmer is shut down for maintenance, inspection or storage,
switch off the engine, pull the spark plug connector off the spark plug
and ensure that all rotating parts have come to a standstill. Allow the
machine to cool down before carrying out an inspection, settings, etc.
b) Store the hedge trimmer where the petrol vapours cannot come into
contact with flames or sparks. Always allow the hedge trimmer to cool
down before storage.
c) When transporting or storing the hedge trimmer, cover the cutting unit
with the protective cover for the cutting unit.
6
Complementary safety instructions for hedge
trimmers
Environmental safety
■ Only operate the hedge trimmer in daylight or good artificial light.
■ While trimming, ensure that you do not come into contact with objects
such as fence wire or plant supports. They could cause damage to the
cutter bar . Inspect the hedge to be cut carefully and remove any
wires or other foreign bodies.
■ Be aware of your environment and all possible hazards that you may
be unable to hear while cutting the hedge.
DANGER!
► In the event of imminent danger or an emergency, switch off the
engine immediately.
Electrical safety
■ Hold the power tool only by the insulated grips as the cutting blades
could come into contact with hidden power lines. Contact between
the blades and a live wire may make exposed metal parts of the power
tool live and could give the operator an electric shock.
Personal safety
■ During operation, no other person or animal may be within a radius
of 15 metres. The operator is responsible for third parties within the
working area.
■ During operation, ensure that you have proper footing and balance at
all times, especially when used on steps or ladders.
■ Never grasp the hedge trimmer by the cutter bar
■ Keep your hands away from the cutting blades. Do not attempt to
clear cuttings or hold onto the material to be cut while the blades
are still in motion. Remove any jammed clippings only when the
appliance has been switched off. A moment of inattention while oper-
ating the hedge trimmer may result in serious personal injury.
■ Wait until the tool has come to a standstill before putting it down.
Use and handling
CAUTION!
► Between tasks or after completion of a task, do not set the cutter bar
down on its tip as this could cause damage to the cutter bar
■ Before use, always check that the blades, the blade screws and other
parts of the cutting tool are not worn or damaged. Never work with a
damaged or heavily worn blade.
■ After making settings to the working angle, check whether both setting
levers are clicked firmly into place. If one of the setting levers remains
open, the second could be unintentionally be released by a branch
and the cutter bar could swing down.
■ Never use the hedge trimmer with defective or missing safety guards.
■ Never grasp the hedge trimmer by the safety guards.
■ Carry the hedge trimmer by the front handle when switched off, and
with the cutter bar facing away from your body. When transporting
or storing the trimmer, always put on the protective cover. Careful
handling of the appliance reduces the likelihood of accidental contact
with the moving blades.
■ Store the hedge trimmer in a dry, high or closed space out of the reach
of children.
■ Do not attempt to repair the equipment unless you have received the
necessary training.
■ For safety's sake, change worn or damaged parts.
DANGER!
► In the event of imminent danger or an emergency, switch off the
engine immediately.
.
.
FBK 4 A1