Setup Instructions - TECHCON SYSTEMS TS5622VU-DVD Manuel D'utilisation

5. SET UP INSTRUCTIONS
Refer to figure 4.0
1. Install the bracket (1) to the valve if needed.
2. Connect the fluid reservoir feed tube to the valve inlet port (2).
3. Connect the one end of the valve airline to the air inlet port (3) and the other end to the valve
controller or other pneumatic device that is used to control the valve.
4. Connect appropriate dispensing tip (5) to the fluid outlet port (4) then secure it with the needle
cap (6).
5. Set the valve controller pressure at 70 psi (4.8 bars)
6. Set the fluid reservoir pressure. Do not exceed 70 psi (4.8 bars)
7. Make sure all connections are tight
8. Place container under the valve outlet and activate the valve until the fluid flows steady.
The amount of fluid that flows through the valve is determined by:
• Valve open time
• Fluid reservoir pressure
• Dispensing tip size
1
2
6
Figure 4.0
5
3
4
5