Specifications; Features; Connecting The Valve; Operating Instructions - TECHCON SYSTEMS TS5540 Guide De L'utilisateur

2.

SPECIFICATIONS

Size 104.1 x 25.4 mm (4.1" x 1.0")
Weight 331g (0.73lb)
Fluid Inlet Port 1/8" NPT female
Air Inlet Port 10-32 UNF-2B
Atomize Air Inlet Port 10-32 UNF-2B
Fluid Pressure 100 psi (6.9 bar) maximum
Activation Pressure 70 psi (4.8 bar) minimum
Wetted Parts 303 stainless steel, Delrin®, Telfon®
Air Cylinder Material 303 stainless steel
Operating Frequency Exceeds 400 cycles/min.
Teflon® and Delrin® are registered trademarks of E.I. DuPont.
3.

FEATURES

Items # Description
1 Stroke Control Adjustment
Knob
2 Valve-actuating Air Inlet Port
3 Fluid Inlet Port
4 Removable Spray Cap
5 Atomize Air Inlet Port
1
5
Figure 1.0
4
2
4.

CONNECTING THE VALVE

Item # Description
1 From air source
2 Air Filter (optional)
3 Constant air flow
4 Valve Air Hose (included)
5 Atomize Air Hose (included)
6 Fluid Feed Hose (optional)
7 Fluid Reservoir (TS1258 - optional)
8 Valve Controller (TS5110 - optional)
2
3

5. OPERATING INSTRUCTIONS

1. Set valve air pressure at Valve Controller to 70 psi (4.8 bar).
2. Set the atomize air pressure at Valve Controller according to the viscosity of fluid
being spray.
3. Set fluid pressure at Fluid Reservoir according the viscosity of fluid being sprayed;
do not exceed 100 psi (6.9 bars).
4. Place a waste bucket under the valve spray nozzle and purge the valve until the
fluid flows steadily.
Spray coverage is determined by:
•
Stroke control adjustment – Rotate Stroke Control Knob clockwise to
decrease flow rate and counterclockwise to increase flow rate. DO NOT
rotate the knob beyond the "Line Marker" which is labeled on the knob
shaft.
•
Length of actuation as set at Valve Controller (the "valve-on" time)
•
Fluid reservoir pressure
•
Fluid viscosity
•
Distance between the spray nozzle and the sprayed surface
3
1
4
2
5
MODE DECIMAL
MODE/TIME DISPLAY TS5540
MODE/TIME SET
8
Figure 2.0
3
6
7