Absaar HV04 Instructions D'utilisation page 12

12
CURRENT SELECTOR SWITCH
If your charger does not have a current selector switch:
The charger will detect the required battery charging current automatically.
A/M Switch ( Automobile / Motorbike ):
Depending on the battery charger type it may feature an AUTOMOBILE – MOTORBIKE switch.
The Motorbike position will supply a lower charging current to charge batteries with a capacity
between 5 and 15 Ah.
N/E Switch ( Normal / Express Charge ):
Depending on the battery charger type it may feature an NORMAL – EXPRESS switch. Setting the
switch to the NORMAL position will charge the battery with a lower charging current, resulting
in a longer charging time. This position is intended for batteries with very low capacities. Normal
charging will extend the battery life. The EXPRESS position will supply a charging current up to the
maximum current.
BATTERy SELECTOR SWITCH ( STANDARD / AGM-GEL):
Use the „Battery Type" selector switch to choose the type of battery you want to charge. Select
"Standard" for normal lead-acid batteries or select "AGM-GEL" for maintenance-free and gel
batteries.
Caution: It is very important to set the proper battery type (whenever a battery selector switch
exists for your model of charger). This switch controls the stopping of the battery charging process.
If you don't know the type of battery, please contact the battery or vehicle manufacturer. 6-cell
batteries typically have a nominal voltage of 12 V.
INDICATORS FOR STANDARD CHARGERS
The green LED lights as soon as the battery is fully charged.
An ongoing charging process is indicated by the yellow LED lighting.
The red LED illuminates when the battery clamps have been reversed.
DIRECTIONS OF USE