Connection And Maintenance Of Ventilation (Optional); Technical Specifications - Nordica KIT VENTILAZIONE OPTIONALE 6018090 Instructions Pour L'installation, L'utilisation Et L'entretien

6098090 KIT VENTILAZIONE OPTIONALE

1. CONNECTION AND MAINTENANCE OF VENTILATION (OPTIONAL)

The control unit and the plant must be installed and connected by authorized personnel according to the standards
in force. (see chapter GENERAL REMARKS).
ATTENTION: the control unit and the feeding cable must not be in contact with hot parts.
On our products, it is possible to install Optional ventilation kits suitable to improve the distribution of heat by ventilation only
either of the installation room or of the adjacent local (see chapter EXTERNAL AIR INTAKE).
For the installation of the Forced Ventilation Kit, follow the given instructions. (see chapter OPTIONAL VENTILATION KIT).
The Kit is made up of a centrifugal fan, a lighting and adjustment control unit, and a (TM) thermostat that lets the fan start
when the device is properly heated and lets it stop when the fan is partially cold.
The lighting and the adjustment is carried out through the proper standard supplied control unit that has to be installed far
from any direct heat source.
CONNECTION (
Picture 1 at page 10
Connect the feeding cable of the switchboard with an electronic bipolar switch respecting at least a 3 mm distance between
the contacts (power supply 230V~ 50 Hz, it is necessary to provide for the correct connection to the grounding plant).
WARNING: The COMMAND must be connected to the mains with a differential line cut-off switch according to the regulations
in force. Correct operation of the command is assured only for the proper motor for which it has been manufactured. Improper
use relieves the manufacturer from each responsibility.
MANDATORY: cable out of seeing !
6098090 - IT - EN - DE - FR
):
POWER SUPPLY
DIMENSIONS
CONTAINER

TECHNICAL SPECIFICATIONS

230 V~ +15 – 10% 50/60 Hz
120 x 74 x 51 mm
Self-extinguishing ABS IP40 V0
TM
Thermostat
EN
7