Trouble Shooting - HOLZMANN MASCHINEN NTS 250 Manuel D'utilisation

17

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
The magnetic support has no
magnetic force
Machine slows down during
working
Bad sharpening result
Sanding disc runs out of round
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix the
problem.
HOLZMANN MASCHINEN GmbH
Possible cause
 ON/OFF-switch damaged
 Saw unplugged
 Fuse blown or circuit breaker
tripped
 Cord damaged
 Exerting too much pressure to
the sanding abrasive
 Wrong angle set
 Grinding wheel is worn
www.holzmann-maschinen.at
 Check the switch
 Check all power connections
 Change fuse or reset circuit
breaker
 Change cable
 Exert less pressure on the work
piece
 Check the set angle and set new
if it is necessary
 Dress grinding wheel
N O T I C E
TROUBLE SHOOTING
Solution
26
NTS 250 / NTS 250PRO