Programming The Thermostat - Atlantic Navilink H55 Mode D'emploi

EN
Description Features
This programmable Room • Ergonomic user interface featuring an 'OK-button'.
Thermostat is designed to
• Large LCD (Liquid Crystal Display) Screen.
control your heating system
• 7-day heating program to match your lifestyle,
efficiently, providing comfortable
temperatures when you are at
home and energy savings when
• 4 independent temperature levels
you are away. The following
instructions explain how to
• Holiday button saves energy by letting you
set up, program and operate
your Room Thermostat.
• Built-in Memory holds the user program indefinitely.
Controls Layout
1 2 3
14
13
12
11
10
10
1 6
LCD Screen Temperature Display
2 Battery Low Indicator 7 Temperature Change Buttons
3 Time Display 8 Temperature Enquiry Button
4 Heating Required Indicator 9 Operating Mode Buttons
5 Day Indicator 10 Green OK Button
12
USER GUIDE
whilst maximising energy savings.
per day (from 5°C to 35°C).
reduce the temperature for 1 to 99 days.
4 5
PROG
11
Holiday Function Button
12 Program Buttons
13 Copy Day Button
14 Day Select Button
15 Time Change Buttons
SETTING-UP THE THERMOSTAT
This section shows you how to setup and run the thermostat in 2 simple steps:
STEP 1: Setting the Day and Time
To set the Day and Time:
a. Press the
b. Press the
Monday). Press the green
d. Press either of the
flashes the time digits (when the unit is powered for the first time the display shows 12:00).
e. Use the
confirm. Each press of the buttons will change the time by one minute and holding
them down will change the time slowly at first and get progressively quicker.
Note: If this mode is entered accidentally then press the
STEP 2: Running the Built-in Heating Program
The thermostat is now ready for operation. Press the
heating program will start running. Note: The built-in heating program has been
designed to provide normal comfort requirements, but if you want to customise
6 the settings please see the next section 'Programming the Thermostat'.
7

PROGRAMMING THE THERMOSTAT

The Built-in Heating Program
The built-in heating program has 4 temperature level changes per day that can be set
between 3.00am and 2.50am the following day - allowing you to maintain the evening
temperature after midnight. Each temperature level can be set between 5°C and 35°C,
and adjusted in 0.5°C increments. The factory default program for heating is as follows.
8
Monday to Friday
(DAY 1 to 5)
9
Saturday & Sunday
(DAY 6 & 7)
Reviewing the Heating Program
To review or edit the heating program use the PROGRAM
between the 4 individual programming periods for that day. Use the
each day of the week, so the complete 7 day heating program can be reviewed or edited.
button once and the 'day indicator' will begin to flash.
button until the correct day is reached (Day 1 =
button to confirm.
or buttons once to enter time setting mode. The LCD screen
or buttons to set the correct time then press the green
button and the built-in
Period 1 2
Time 6:30 8:00
Temperature 21°C 18°C
Period 1 2
8:00 10:00
Time
21°C 21°C
Temperature
EN
button to
, or buttons to exit.
3 4
12:00 22:30
21°C 16°C
3 4
12:00 23:00
21°C 16°C
or buttons to navigate
button to step through
13