DITEC CROSS3E Manuel D'installation Et D'entretien page 14

3.5 CROSS3TC installation
GB
- Remove the cover [F] and the retaining ring [G] and slide out
the pinion [17].
- Insert the pinion [L], the spacer [J] and fasten with the
seeger [G].
- Replace the cover [F].
- Secure the chain striker bracket [E].
17 G F
3.6 Chain installation
- Release the geared motor (see OPERATING INSTRUC-
TIONS) and pass the chain between pinion [L] and stop
[E] by turning the pinion manually.
With the chain supplied, the gate has a maximum stroke
of 5.7 meters.
- Open the gate and attach brackets [C] to the leaf as shown
in figure.
- Connect the chain previously installed on the geared motor
to rod [D] and attach it to bracket [C].
- Attach the chain to the other side of the gate by means of
rod [D] and bracket [C] (cut off excess chain).
Note: with the gate in complete opening and closing posi-
tion, check that the distance between the center of pinion
[L] and rod [D] shown in figure is respected.
- Finally, firmly secure the geared motor by nuts [A].
- Tighten the chain with rods [D]. Lubricate the chain and
pinion lightly after assembly.
CROSS3E - IP1780
E J
G
L
min 60
D C
L
F
4. ELECTRICAL CONNECTIONS
The electrical connections and starting are illustrated in the
installation manual of the control panel.
ATTENTION: Connect the yellow-green ground cable to the
clamp already connected to the motor, as it is shown in the
figure.
yellow-green
5. CROSS3SF INSTALLATION (fig. 4)
Additional photocells can be installed inside the gear motor
utilising the optional CROSS3SF kit, so as to protect the closing
movement as well as the opening movement.
Assemble a receiver (RX) or a transmitter (TX) on the brackets
supplied, as shown in the figure.
Installation of the photocells must be carried out in observance
of the standards EN12453 and EN12445.
Attention: the photocell receiver (RX) and transmitter (TX) may
also be installed at two different heights, the maximum permis-
sible difference in height being 300 mm.
6. LUXK3E INSTALLATION (fig. 5)
The LUXK3 kit permits to illuminate the area around the au-
tomatic gate for a period of 3 minutes upon the appropriate
command being given.
Secure the kit by means of the three screws provided and con-
nect to control panel as shown in the figure.
To route the leads inside the control panel, cut out the plastic
sheath at the marked spot (see LUXK3E instructions).
After the connections, mount the cover.
14
F E L
D H