Defrost water
Defrost water is led through a tube in the insulation, down to a tray under the cabinet.
A heating element in the tray re-evaporates the water. It may be necessary to clean
the re-evaporation tray, minimum once a year.
The tray can be removed from the rear of the cabinet, without using tools.
Door closing mechanism
The door is equipped with a self-closing system.
Flourescent tube replacement
Note! Remember to disconnect the appliance at the socket before replacing the
fluorescent tube.
In the 425 l cabinet the fluorescent tube is located inside the cabinet on the left. In
the 625 l cabinet there is a fluorescent tube on both sides. The tubes are placed
behind a protective screen and behind the screen on the illuminated top panel.
Access to the cabinet fluorescent tube can be gained by loosening the two screws in
the protective screen. Then press lightly on both sides at the top of the screen and
draw it out. The defective fluorescent tube can now be replaced and the screen
refitted.
Access to the fluorescent tube behind the screen on the illuminated top panel can be
gained by removing the righthand end piece after loosening the top and bottom
screws in the end piece (see drawing under "starting up"). The plastic sheet in front
of the control and the fluorescent tube can now be removed. The defective tube can
then be replaced and the screen and end piece refitted.
Power failure
On power failure, the control remembers the temperature setting and restarts the
cabinet when current is restored. If the power failure persists for some time, the
control might revert to the factory setting.
Cleaning
The cabinet should be cleaned internally with a mild soap solution at suitable
intervals and checked thoroughly before it is put into operation again.
Cleansing agents containing chlorine or compounds of chlorine as well as other
corrosive means, are not to be used, as they might cause corrosion to the stainless
panels inside the cabinet and the evaporator system.
The compressor compartment and in particular the condenser must be kept free from
dust and dirt. This is best done with a vacuum cleaner and a brush.
76-504-0961
15/GB
Gram-webshop.nl
Gram-webshop.nl