AUDIOropa xepton-NX TX Mode D'emploi page 16

2.4 Adjusting input sensitivity
The input sensitivity can be adjusted in 5 levels
according to environmental requirements.
On the powered-up device, press and hold the
MODE-button for 3 seconds.
The symbol »CH« in the display will blink.
Press the MODE button again. The »C1« symbol
in the display blinks.
By using the » « and » « buttons, select be-
 
tween C1 (low sensitivity) and C5 (high sensitivity).
Please note: The default setting is C3.
2.5 Encryption
If the use of Xepton-NX requires discretion, such
as in court buildings or during private sessions,
the communication between transmitter and
receiver can be encrypted. Other Xepton-NX de-
vices can then no longer participate in the com-
munication.
For this purpose, basic settings on the involved
devices must be changed - please contact your
authorized AUDIOropa dealer.
English 16